Lokar EC-8002HT (38-48 Dodge) Connector Cable User Manual download pdf

Building American Quality… With A Lifetime Warranty!

Connector Cable Installation Instructions

Part# EC-8002U & EC-8002HT (38-48 Dodge)

For Under-the-Dash Hand Operated Emergency Brake

Connector Cable Installation

Step 1: Install outer housing to hand brake with bracket as

shown in Fig. 1.

Step 2: Run housing back to rear cables. If you are using a

Lokar Universal Rear Emergency Brake Cable Kit,

mount connector cable bracket 9 1/2” from rear

cable adjuster as shown in Fig. 2.

Step 3: Run inner cable from hand brake, using clevis at

hand brake. Make sure hand brake is in the full off

position.

Step 4: Be sure to adjust the adjusters all the way in when

connecting cables as shown in Fig. 2.

Step 5: Adjust all cables as needed to remove any slack.

Fig. 1

Fig. 2

9 1/2”

Connector Cable Installation

EC-8002U & EC-8002HT (38-48 Dodge)

General Installation Notes:

Please read instructions completely before beginning

installation. If you have any questions please call.

NOTE: Before starting installation, set parking brake

and scotch vehicle to avoid accidental movement of

the vehicle. Disconnect battery cable before starting

installation.

Rev. 5/3/05

10924 Murdock Dr. • Knoxville, TN 37932

TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com

Building American Quality… With A Lifetime Warranty!Connector Cable Installation InstructionsPart# EC-8002U & EC-8002HT (38-48 Dodge)For Under-the

No comments

Lokar EC-8002HT (38-48 Dodge) Connector Cable User Manual